How Tight?

Halk

Junior Member

jeudi 3 mars 2005, 23:07

1

Installing Aquacomputer into my new V2000B, how tight should I be turning the connections? I realise I can use a spanner, but I'd rather not apply to much pressure should it be enough with the pressure I can apply with my fingers?

If I leaktest it, and it's leak free, will it remain leak free?

NikoMo

NikoMod

Re: How Tight?

jeudi 3 mars 2005, 23:24

2

hi, and welcome to the board

a little bit more than you can apply with your fingers is the best.

normally it should be and stay leak-free, after you've made a leaktest.

von all den dingen die mir sind verloren gegangen,
habe ich am meisten an meinem Verstand gehangen

Halk

Junior Member

Re: How Tight?

vendredi 4 mars 2005, 00:04

3

Thanks for the welcome.

Another little question, turns out the bottom of my Cuplex Pro wasn't completely flat, so I'm lapping it down to 2000 grit. I guess I just got the last one made on a friday afternoon?

back_orifice

God

Re: How Tight?

vendredi 4 mars 2005, 00:08

4

Citation de "Halk"

Thanks for the welcome.

Another little question, turns out the bottom of my Cuplex Pro wasn't completely flat, so I'm lapping it down to 2000 grit. I guess I just got the last one made on a friday afternoon?

if the cooler is not useable, or if the cooling performance would get lower by this, i would send in the cooler, AC will surely send you a new one...

Halk

Junior Member

Re: How Tight?

vendredi 4 mars 2005, 00:12

5

Oh, it's usable, but lapping (using sand paper/glass paper) will give a better finish. I just noticed that the block I have wasn't flat. It's almost flat now though, and will be completely flat and have a mirror finish by the time I'm done

back_orifice

God

Re: How Tight?

vendredi 4 mars 2005, 00:26

6

Citation de "Halk"

Oh, it's usable, but lapping (using sand paper/glass paper) will give a better finish. I just noticed that the block I have wasn't flat. It's almost flat now though, and will be completely flat and have a mirror finish by the time I'm done

diy rulz... ;D ;D