• 24.04.2024, 14:35
  • Register
  • Login

  • You are not logged in.

 

Aquaero 6 PRO + Laing DDC-1T Plus PWM 12 V

Dear visitor, welcome to Aqua Computer Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Piospi

Newbie

Posts: 9

Aquaero 6 PRO + Laing DDC-1T Plus PWM 12 V

Monday, January 5th 2015, 3:06pm

Hello everyone,


I would like to buy Aquaero 6 PRO for my four fans and pump Laing DDC-1T Plus PWM 12V.

How to connect the pump? I must connect molex to PSU power supply and PWM to Aquaero?

Do I need a heat sink for AQ6 PRO + 4 fans + Laing DDC-1T 12V and two temperature sensors?


Regards

InfoSeeker

Senior Member

Posts: 1,762

Tuesday, January 6th 2015, 6:17am

Yes, the pump power will come from a 4 pin molex from your psu, and then connect the pwm plug to a aquaero 6 pro pwm port.

The aquaero 6 controls fans digitally, so you probably will not NEED a heat sink for it, but it is not expensive if you want to install one. They look cool.

Piospi

Newbie

Posts: 9

Sunday, January 11th 2015, 11:32am

Thank you :)


I would like to buy a FlowMeter, but do not know which one. GMR FlowMeter with electronics is accurate?

InfoSeeker

Senior Member

Posts: 1,762

Sunday, January 11th 2015, 3:41pm

I am not familiar with the GMR FlowMeter product, but if you are buying an Aquaero 6 Pro, you may want to get a Flow Sensor that takes advantage of the aquabus interface of the Aquaero 6 Pro. Just determine which of the 3 sensors best match the flow volume you anticipate having in your loop. Additionally the MPS flow sensors are not mechanical, so they should effect flow rate less.

I have one of the MPS flow sensors for the new radiator system I am building, but it has not been used in anger yet.

I have been advised by AquaComputer to not place an angle fitting at or near the inlet, as that introduces turbulence that effect the sensors. And that makes sense, as turbulence, by definition, has varying velocities in the stream which will then confuse the device.

Similar threads