• 27.04.2024, 19:55
  • Registrieren
  • Anmelden

  • Du bist nicht angemeldet.

 

High Flow Next Installation, angled fittings OK?

Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies dein erster Besuch auf dieser Seite ist, lese dir bitte die Hilfe durch. Dort wird dir die Bedienung dieser Seite näher erläutert. Darüber hinaus solltest du dich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutze das Registrierungsformular, um dich zu registrieren oder informiere dich ausführlich über den Registrierungsvorgang. Falls du dich bereits zu einem früheren Zeitpunkt registriert hast, kannst du dich hier anmelden.

PA3Q

Junior Member

Beiträge: 7

High Flow Next Installation, angled fittings OK?

Freitag, 4. Dezember 2020, 10:07

A basic question I guess, but I am building my first liquid cooled computer.

Should the sensor be installed with a straight line of tubing before and after, for the flow to be accurate?
Or will it work properly with 45 degree/angled fittings before/after the sensor also?

sebastian

Administrator

Beiträge: 10 519

Freitag, 4. Dezember 2020, 10:58

Any turbulence in the flow has an influence on the measurement. An angle in front of the sensor will influence the measurement. By how much is difficult to say.
You can only correct this by comparing the sensor with a reference in your system.

PA3Q

Junior Member

Beiträge: 7

Freitag, 4. Dezember 2020, 11:57

Zitat von »sebastian«

Any turbulence in the flow has an influence on the measurement. An angle in front of the sensor will influence the measurement. By how much is difficult to say.
You can only correct this by comparing the sensor with a reference in your system.
Thank you for the reply.

So, I should probably install the sensor with a couple of centimetres of straight tubing in front and after, to get the most correct measurement.

With 5 out of 10 fittings being 90 degree already, I guess the flow will be drastically lowered.

Ähnliche Themen