• 28.04.2024, 14:45
  • Register
  • Login

  • You are not logged in.

 

What's happening here?

Dear visitor, welcome to Aqua Computer Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

InfoSeeker

Senior Member

Posts: 1,764

What's happening here?

Thursday, December 3rd 2020, 9:54pm

I have the controller set to show magenta when the source is below 15, and white when the source is above 15 controller.jpg

This has been working fine, but today I started getting a few of the LEDs showing green/yellow with the source at 19 leds.jpg

Has the strip gone bad?

InfoSeeker

Senior Member

Posts: 1,764

Thursday, December 3rd 2020, 11:46pm

I have two RGBpx LED strip 27.3 cm, width 5 mm, 30 addressable LEDs. The horizontal strip across the top is a full 30 LEDs, and connects to the vertical strip which was cut between LED 23.and 24.

When I delete the controller, the last 15 LEDs on the vertical strip are still lit. It appears I have no control of the last 15 LEDs of the vertical strip, controller or no.

controller_off.jpg
leds.jpg

sebastian

Administrator

Posts: 10,519

Friday, December 4th 2020, 7:14am

Use liter/hour. Reset the device to factory defaults and set all leds with one controller to a fixed color. is this is working?
Otherwise the strip is defect.

InfoSeeker

Senior Member

Posts: 1,764

Friday, December 4th 2020, 1:34pm

Looks like the strip is fail... lasted about 9 months or so :/

Similar threads