Du bist nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies dein erster Besuch auf dieser Seite ist, lese dir bitte die Hilfe durch. Dort wird dir die Bedienung dieser Seite näher erläutert. Darüber hinaus solltest du dich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutze das Registrierungsformular, um dich zu registrieren oder informiere dich ausführlich über den Registrierungsvorgang. Falls du dich bereits zu einem früheren Zeitpunkt registriert hast, kannst du dich hier anmelden.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »alexkyriak« (29. November 2021, 10:10)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »InfoSeeker« (29. November 2021, 11:50)
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von »InfoSeeker« (29. November 2021, 14:22)
Hi all, I was wondering if anyone could advise. I am building a system with dual D5 NEXT pumps on one loop. The pumps will be sequential (in series).
In terms of the connections diagram of the pumps, what's the best way to do this? Should I smply connect each pump to a USB header on the motherboard? Or do I need to send one signal to control both pumps? Obviously I want to keep the pumps in synchronisation. What's the best way to achieve this setup and control?
thanks, and much appreciated!
Hi all, I was wondering if anyone could advise. I am building a system with dual D5 NEXT pumps on one loop. The pumps will be sequential (in series).
In terms of the connections diagram of the pumps, what's the best way to do this? Should I smply connect each pump to a USB header on the motherboard? Or do I need to send one signal to control both pumps? Obviously I want to keep the pumps in synchronisation. What's the best way to achieve this setup and control?
thanks, and much appreciated!
-