Du bist nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies dein erster Besuch auf dieser Seite ist, lese dir bitte die Hilfe durch. Dort wird dir die Bedienung dieser Seite näher erläutert. Darüber hinaus solltest du dich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutze das Registrierungsformular, um dich zu registrieren oder informiere dich ausführlich über den Registrierungsvorgang. Falls du dich bereits zu einem früheren Zeitpunkt registriert hast, kannst du dich hier anmelden.
Zitat von »Infiltraitor«
Are you planning on using AS5 or something to mount the block, coz I've been led to believe having a perfectly flat surface isn't so good for heat transfer through the paste.
Zitat von »boswell«
out of interest, why does it matter at all? It seems to me like all you do is post near-pointless posts onto this forum which clutter it up.
Zitat von »boswell«
out of interest, why does it matter at all? It seems to me like all you do is post near-pointless posts onto this forum which clutter it up.
Regards
PS: Stefan das siehst du doch auch so
Zitat von »Ze@lot«
i thought the whole point of this forum was that people could post questions. so that they could get some advise from AC & other people using this forum.
if i had a very expensive water block like the silver XT id also want to know if its ok to remove that much material.
all TN was asking for was a yes or no answer, but all i see is a lot of flaming
Zitat von »Mr_modnaR«
Just keep tightening, till you see the plexiglas crack.
;D lol just thought i'd bring a little humour back into the thread, seems to have gotten a little negative.
Zitat von »boswell«
hi @ all,
I am just wondering why do u want to know the "flatness specification" ? because i do not see any difference between 0.0001mm and 0.0002 mm flatness.
-