You are not logged in.
Dear visitor, welcome to Aqua Computer Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.
Quoted from "Infiltraitor"
Are you planning on using AS5 or something to mount the block, coz I've been led to believe having a perfectly flat surface isn't so good for heat transfer through the paste.
Quoted from "boswell"
out of interest, why does it matter at all? It seems to me like all you do is post near-pointless posts onto this forum which clutter it up.
Quoted from "boswell"
out of interest, why does it matter at all? It seems to me like all you do is post near-pointless posts onto this forum which clutter it up.
Regards
PS: Stefan das siehst du doch auch so
Quoted from "Ze@lot"
i thought the whole point of this forum was that people could post questions. so that they could get some advise from AC & other people using this forum.
if i had a very expensive water block like the silver XT id also want to know if its ok to remove that much material.
all TN was asking for was a yes or no answer, but all i see is a lot of flaming
Quoted from "Mr_modnaR"
Just keep tightening, till you see the plexiglas crack.
;D lol just thought i'd bring a little humour back into the thread, seems to have gotten a little negative.
Quoted from "boswell"
hi @ all,
I am just wondering why do u want to know the "flatness specification" ? because i do not see any difference between 0.0001mm and 0.0002 mm flatness.
-