Hi,I'm a proud owner of an kryos silver edition. but I have a problem: while the block is working fine , in my loop immediately after the kryos I have an EK ram block nickel plated:and this block at the entrance,the nickel has corroded/flacking big time ,toghether with it's fitting:a bitspower elbow this also nickel plated.the nozzle part of the fitting has practically disappeared
http://imageshack.us/a/img267/6122/sam3148d.jpg
http://imageshack.us/a/img836/9447/sam3141.jpg
http://imageshack.us/a/img440/6735/sam3136k.jpg
so I know ,if I ask EKWB ,they will undoubtedly blame the silver kryos...and since there are not a lot of silver blocks out there ,I would like to have your opinion about this ,is the bad nickel,or really the silver could provoke such a reaction?
what can I do to prevent this in the future?
in my loop I used only the premixed cooland from EKWB .the copper top of the Kryos,and two aquaero 5 block were also nickel plated,not by EKWB with it's new EN plating,but by a guy near my house,and these pieces are still spotless.
btw.about the kryos;what product do you reccomend to clean the silver micropins? currently I use a soft toothbrush and dishwasher,but some very small black stains do not come out...
thanks.