Sie sind nicht angemeldet.
Yep, that's what is happening.... I have the MPS 400, connected via 4 wire Aquabus. And as I said when you enable it, you lose FAN1..... My MPS tab stays there in AS2012 when I disconnect it from USB and there is a big X in it and you can't do anything.......I begin to see the problem!
I have a mps 100 flow installed. When connected via USB, I have a tab for it in AS2012 that allows selection of the calibration curve.
When connected by 4 wire Aquabus and USB, I get the internal temp sensor values and the option of selecting a calibration curve.
When connected only by 4 wire Aquabus, I get only the option of selecting a calibration value, not the calibration curves. And of course, the seperate tab goes away in AS2012.
This is not good.
Dieser Beitrag wurde bereits 6 mal editiert, zuletzt von »Jakusonfire« (31. Dezember 2012, 15:55)
-