Sie sind nicht angemeldet.
Zitat
4.3. Anschluss „Lüfter 1/2/3/4“
Geregelte Lüfterausgänge mit Tachosignalauswertung. Die maximale Belastbarkeit
jedes Ausgangs beträgt 19,8 W (1,65 A bei 12 V). Die Belastbarkeit
ist dynamisch begrenzt durch Temperaturüberwachung.
©
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »EnigmaG« (23. März 2013, 11:08)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Pilo« (23. März 2013, 12:46)
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von »pegleg« (31. März 2013, 19:09)
Dieser Beitrag wurde bereits 3 mal editiert, zuletzt von »Jakusonfire« (18. April 2013, 03:13)
Now you have me wondering if you have a great batch of PA2's or if I have a very poor batch. Are you saying you are able to overload a PA2 to 2.5A-4A then undervolt it without it cycling?Interesting. I agree it must relate to the type of fans.
I have ran as few as 3 AP-15's seriously undervolted from a PA2, and never saw the PA2 temps rise above the low 60's.
On another PA2 I was once running 5 AP-15's undervolted considerably with no problems.
I've since changed to running dual Aquaero's & no PA2's but that was related to having another pwm fan header, not PA2 problems.
Cooling the PA2's with a separate fan sounds like a good solution, is that not working well enough?
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »tpb211« (20. April 2013, 03:11)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »mandrix« (20. April 2013, 03:15)
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von »tpb211« (20. April 2013, 07:04)
Seeing as you have 40 of the fans then surely you don't need all the speed the fans offer?
If you use low noise adaptors or voltage reducers on the fans to lower their top speed it means the fans need to be undervolted less to reach the minimum speed you want, and therefore less heat.
I really wanted to try the eLoops but the current draw put me off even on the B12-3's ... I notice in several reviews I have seen that the fans don't reach their rated top speed. I wonder if this means that they need a while to run in and reduce friction on their bearing system? If it does that would mean that load would decrease over time as you use the fans.
Dieser Beitrag wurde bereits 6 mal editiert, zuletzt von »tpb211« (20. April 2013, 23:26)
-