• 19.04.2024, 18:36
  • Registrieren
  • Anmelden

  • Sie sind nicht angemeldet.

 

Aquaero5 xt and mcp35x2

Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.

pilotter

Junior Member

Beiträge: 12

Aquaero5 xt and mcp35x2

Freitag, 12. April 2013, 10:03

Good day,


does someone has a mcp35x2 pump(s) connected to the aquaero 5 and working properly? what I would like to see , make possible control of the pumps ( same speed ) and readout of both pump rpms separate.

Jakusonfire

Full Member

Beiträge: 306

Sonntag, 14. April 2013, 12:28

Swiftech has a PWM splitter cable that will allow you to connect both pumps together for control by the fan 4 header and it has a seperate 3 pin header that connects to one of the other fan headers and will give the RPM's of the second pump.

http://www.swiftech.com/PWMsplittercable.aspx

tpb211

Junior Member

Beiträge: 33

Mittwoch, 17. April 2013, 23:11

Just be sure to go to the fans tab, advanced setting and make sure PWM is checked and you shouldn't have a problem. As stated above use the included Y-splitter and send the second feed to ch.3 or another channel on the aquero and it will show you both rpm's. You will be able to control both rpms simultaneously via making adjustments to ch.4
I am running a pair of MCP35x2's in my build if you have any questions just ask! Great pumps!

pilotter

Junior Member

Beiträge: 12

Freitag, 26. April 2013, 05:56

Zitat von »tpb211«

Just be sure to go to the fans tab, advanced setting and make sure PWM is checked and you shouldn't have a problem. As stated above use the included Y-splitter and send the second feed to ch.3 or another channel on the aquero and it will show you both rpm's. You will be able to control both rpms simultaneously via making adjustments to ch.4
I am running a pair of MCP35x2's in my build if you have any questions just ask! Great pumps!
thanks, so it will be shown as a fan? But than you can control the 2 pumps simultaneously and read the rpm, great. :thumbsup:


Zitat von »Jakusonfire«

Swiftech has a PWM splitter cable that will allow you to connect both pumps together for control by the fan 4 header and it has a seperate 3 pin header that connects to one of the other fan headers and will give the RPM's of the second pump.

http://www.swiftech.com/PWMsplittercable.aspx

Ähnliche Themen