Sie sind nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »DrHarvey12« (6. August 2013, 17:23)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »DrHarvey12« (7. August 2013, 19:07)
I've put together a basic start up guide for setting up the Aquaero 5 HERE Scroll down the page abit past the installing the water block & you'll get to the screen shots & guide for Updating the Firmware & setting up your first Curve Control.. It may look rather daunting, but don't let that put you off, Once you get to give it a shot I'm sure you'll begin to pick it up no problem.... Trust me!! ...Hi guys,
Thanks for taking the time to reply.
I was really hoping to avoid having to set it up from scratch if possible as like I said it is currently working fine - basically being completely un-obtrusive but ramping up the fan speed based on the temperature of the fluid in the loop. I don't need it to do any more than it currently does. However I take your point about getting to know it - that might be the way I have to do it if I can't get the software from anywhere else.
I looked at the quick installation guide for the Aquaero 5 which seems to be the only available manual for it and that wasn't exactly a great deal of help. Is there a noob friendly guide for setting up Aquasuite 2013 anywhere I could have a look at to see if it's something I would want to attempt?
I'd still be really interested in finding somebody that had the Beta 14 s/w. If I have an easy to re-install setup it's less of an issue to go to 2013 and try it knowing if I get hopelessly lost / confused I can go back to a 2012 beta 14 profile which will work.
Out of interest could I download and install the 2013 software but keep the 2012 with the working profile on my PC but not running so to speak? Then if I get 2013 working fine I can un-install the 2012 stuff and if I don't I can just go back to using the 2012 profile which works fine.
Thanks again for any help / advice.
It is much appreciated
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Namron« (7. August 2013, 21:13)
-