Sie sind nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
Have you updated the firmware for the LT as well?..... Pretty much all & any MPS devices along with any LT slave device will need an update as well ... I would also recommend saving your settings "Profile" to a separate folder other than the default folder that Aquasuite uses.. You can simply then re-upload this to get all your main settings back as they were before any update was performed.. Although the any personal names that you gave to your Tab menu's will be gone & you will need to just redo these...I upgraded the software and after the firmware upgrade my LT Slave Device doesn't show up any longer. What do I need to do?
The upgrade was from Aquasuite 2013-R2 to Aquasuite 2013-R3
mybeat
unregistriert
That's the thing, the LT Slave doesn't show up any longer, so how do I upgrade it's firmware?Have you updated the firmware for the LT as well?..... Pretty much all & any MPS devices along with any LT slave device will need an update as well ... I would also recommend saving your settings "Profile" to a separate folder other than the default folder that Aquasuite uses.. You can simply then re-upload this to get all your main settings back as they were before any update was performed.. Although the any personal names that you gave to your Tab menu's will be gone & you will need to just redo these...I upgraded the software and after the firmware upgrade my LT Slave Device doesn't show up any longer. What do I need to do?
The upgrade was from Aquasuite 2013-R2 to Aquasuite 2013-R3
This update may not overwrite any previously saved profiles in the default Aquasuite "save profile" folder.. I don't know.. But I always make a separate folder for all my saved profiles, that way when you do update the firmware Aquasuite will not overwrite as it sometimes has in the past it's default profile folder...
N.
AH!!!... Sorry about that.... I didn't have my Slave LT in the build to try it myself & was just guessing.... I've put the slave LT in now & yup.. It's working fine, all the sensors are there e.t.c without having to update the slave LT firmware .....You don't need to update the firmware of the aquaero 5 slave.
If you like to do a firmware update, you need to bring the device to recovery mode by adding jumpers to temperature sensor 5+6+7+8. Then restart the device and wait for the beep. Restart the aquasuite and you can update the firmware.
You're right, didn't need to update firmware, just needed to do a proper restart of my machine, or more precisely not a restart but a full shutdown and then startup of my machine and the LT re-appeared. Imported my saved settings and pages and I'm back to normal.You don't need to update the firmware of the aquaero 5 slave.
If you like to do a firmware update, you need to bring the device to recovery mode by adding jumpers to temperature sensor 5+6+7+8. Then restart the device and wait for the beep. Restart the aquasuite and you can update the firmware.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Megalamaniac« (11. November 2013, 13:31)
-