i need help with aquaero 6xt + multiswitch setup

Junior Member

i need help with aquaero 6xt + multiswitch setup

Samstag, 3. Mai 2014, 18:01

ok. so i can use the multiswitch via usb and aquasuite 4.xx without issue.

updated to most recent firmware.

reinstalled aquasuite 2014.

shut off, installed jumper 3 and removed usb.

installed aquabus cable on multiswitch ( both aquabus channels ) and on LOW speed aquabus on aq6xt.

i can not get aquaero 2014 to recognize it, am i doing something wrong ?

micpt

Junior Member

Beiträge: 47

Montag, 5. Mai 2014, 20:42

when connected via aquabus - you will find the multiswitch options under Aquero Output. There you will find the 8 LED Out´s and also the 8 Power Out´s.
Via Aquabus MS will not be shown as own unit.

In my Screenshot Multiswitch options start with MS1

Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »micpt« (5. Mai 2014, 20:45)

Mega Man

Junior Member

Beiträge: 15

Dienstag, 6. Mai 2014, 04:03

that is the problem.

it is not showing up, it does not even show anything connected via the aquabus ( under settings- devices connected via aquabus )

sebastian

Administrator

Beiträge: 10 522

Dienstag, 6. Mai 2014, 09:35

From the multiswitch manual:

Zitat

Jumper position 5: USB/aquabus
This jumper configures which interface of the multiswitch is active.
Jumper open: USB enabled, aquabus disabled
Jumper closed: aquabus enabled, USB disabled

Mega Man

Junior Member

Beiträge: 15

Dienstag, 6. Mai 2014, 14:55

i knew i forgot something stupid, thanks !~ will test now

i need help with aquaero 6xt + multiswitch setup

i need help with aquaero 6xt + multiswitch setup

Zitat

Ähnliche Themen