Hello,
I'm installing a MPS 400 flow sensor in my new build. I read in the manual the the flow sensor is only calibrated to 10/8mm or 11/8mm fittings and tubing. Is this referring to ID/OD? I'm assuming the manual is referring to ID/OD. I'm using 10/12mm hard acrylic tubing thought out the build. . So I do need the defuser plate installed? I'VE REREAD THE MANUAL AND THE DEFUSER IS USED FOR SMALLER THAN 10/8mm OR 11/8mm. MY TUBING IS LARGER.
If I connect a inline temp sensor to the MPS 400 will it read out in the aqua suite and a regulate inline temp or will it read out as attached or under the MPS 400?
Thank you for any info.
Andy