It about a week or three ago when i did build in the aquaero 6 pro. So for now i am gonna use the relay within the atx power break connector.
So i did purchased one, but when i installed the connector i can´t see the function nearly into the firmware itsefs from the device under outputs. I did flashed the firmware but it gives me no relay feature .
I wanne have the relay function because of an new win 7 boot when i must takeoff the connector from the mainboard after a proper shutdowm whitin a watertemp signal. I know the 5 pro do have the relay function directly into the firmwar so an reset is into the device the manner.