Sie sind nicht angemeldet.
If i recall fifth grade right you get only half the ampere out as normal, if you get the polarity right and the two use the same voltage.
I would´t do it.
I=U/R
This is not pissible.
In the best case both devices shows a wrong temperature. In the worst case one device is damaged.
What is actually with the cheap and simple solution?
Use 2 temperature-sensor pro temperature
This is not possible with a NTC. The ntc is driven from 1 current/voltage source with a reference point. When you connect a sensor to the aquaero, the sebnsor is exclusive used by the aquaero.There are many other usecases where it would be very usefull to have 1 readout go to multiple destination devices.
This is not possible with a NTC. The ntc is driven from 1 current/voltage source with a reference point. When you connect a sensor to the aquaero, the sebnsor is exclusive used by the aquaero.There are many other usecases where it would be very usefull to have 1 readout go to multiple destination devices.
When you attach other cables to this measurment, the measures themperatures are wrong.
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von »Dintid« (5. Februar 2015, 07:52)
-