• 27.04.2024, 02:33
  • Registrieren
  • Anmelden

  • Sie sind nicht angemeldet.

 

Fan splitter and AQ6

dhg66

Newbie

Beiträge: 2

Fan splitter and AQ6

Donnerstag, 12. März 2015, 04:21

trying to control a bank of fans with the AQ6 running to a 8 way PWM fan splitter. The splitter gets power from a SATA power connection (only 2 wires are connected power and ground ) and the fan cable connector from the splitter that goes to the AQ6 only has the RPM wire and PWM signal wire connected. Will this splitter work or do all 4 wires need to connect from the AQ6 ie 12 V, ground, RPM and PWM..and power not come from the SATA power cable.

Would appreciate clarification before I get to wiring things up.

Thanks in advance

Jenko97

Junior Member

Beiträge: 12

Donnerstag, 12. März 2015, 14:01

I think that if you set the fan channel to PWM mode, then only the rpm and pwm signals are sent meaning it should work. I control my pumps that way and they are powered independently from the aquaero by my power supply via molex.

Hope this helps. :)

dhg66

Newbie

Beiträge: 2

Donnerstag, 12. März 2015, 23:32

thank you, sounds like the same set up just molex vs sata power,

Ähnliche Themen