I have installed Aquasuite 2017 on a new computer, which has:
Aquaero 6XT
Farbwerk
(2) Aquacomputer D5 Pumps

I'm trying to set up the Farbwerk to control a RGB Strip based on Aquaero Sensor #1 (CPU temp in my setup).

In Aquasuite 2016-4 (which I have on another computer) when I select Aquaero>Outputs I see a section for "This device" and below that a section "farbwerk 1, output1"

In Aquasuite 2017-1.3 I do not have the "farbwerk 1, output 1" section.

What have I not enabled or set up properly?

RodeoGeorge

I think I solved my problem.
The Aquabus Cable going to the Farbwerk was unplugged.
I plugged it in, and now have the Farbwerk settings.

RodeoGeorge