I have gotten a bit of a problem calibrating the temp sensors in my new PC.
I shut down Windows, turn the power on and check the temps via Aquero 6xt. First I leave it off over night, check in with an hour inbetween to see that all temps are steady and use a new temp probe that is close to the average temp of the room and only a tenth of a degree lower than the amps, as a refference.
Then I tape the refference probe to the plastic "container" that I have placed the probe that meassures roomtemperature in. I then adjust all temp sensors, water and air, to that temperature. When everythibg has stabelized (I check with about an hours interval) I tape it to the water tube (acrylic I believe) and wait until it levels out. The problem is that it then shows several tenths of a degree lower. I did the whole procedure from Sunday night through Monday, and then again from Monday night until now, and the same thing happens.
The problem is that I can not understand why the refference sensor shows almost half a degree LOWER when taped on a warter tube than it does with air. I also placed it, together with the plastic container with the room temp sensor, in a aluminum container, making sure it didn't touch the sides, but the result was the same.
Any suggestions would be welcome.