Sie sind nicht angemeldet.
Freitag, 15. September 2017, 09:32
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von »Hufeisen« (15. September 2017, 16:38)
What if I just removed the +5v wire from the header? Then no power can be sent/received over the USB.Using an external PSU for the Aquaero while it is connected by USB can damage your Hardware!
The USB and the molex connectors are not electrically seperated.
Power from the external PSU can flow into the USB Port of the Motherboard.
This can cause your Motherboard to burn.
All of that is good advice; thank you.The pumps seem to have a low power consumption so I see no problem to connect two of them to one fan port. The aquaero can not tell what you connect to its fan ports so a pump will be always listed as a fan.
It does not matter if you connect the aquaero to an internal or an external USB port - the functionality is exactly the same. Since the aquaero is an autonomous device it does not care if you remove the USB connection while it runs. It will just continue to work with the settings that have been saved before. If you use software temperature sensors they will run into the timeout limit and use their fallback values - all these values can be adjusted.
Using the aquaero with another PSU is not recommended. It can not be said if it will work, behave strange or maybe damages something. It depends a lot on the used PSUs. Well, one of those simple one plug PSUs like from your link is not recommend at all for this kind of setup.
The aquaero will always run in its normal operation mode as soon as it gets 12V so you can not tell it that the PC is turned off and it should stop the fans etc.
The VISION module can display pretty much all information that you can get by hardware monitoring and also the general data from other devices like the aquaero.
You can create fan curves based on the CPU or GPU temperature but usually it is not recommend because these temperature values can jump up and down quite fast without any serious load that would require to speed up the fans. Controlling the fans with the temperature of the water is better in many ways.
-