Thank you Shoggy.
I have another brand new Aquaero 6XT so I switched them and the results were the same I could not get any of my PA to stick in aquasuite aquabus, so...
At the time when this happened I was testing the new PA3 and that unit wasn't connected to Aquabus yet so I try to see if this unit will show up in Aquasuite aquabus and sure enough, there was no issue and non of my 6 PA3 ultra are showing.
I think my Aquaero is good but from bad I think its worse because I think I have damages all of my 6 PA3 and I think even 2 of my USB high flow meters, and that is big expanse.........
You showed me how to test Aquaeros aquabus, I do have good multi meter (Fluke) is there way of me testing PA3 if its damaged or not, if you could show me the same way you did with testing of Aquaeros that would be great
Just checked my USB flow meters, it shows 1.62v that should be OK right
Also, very strange because when I checked both of my Aquaeros and one is brand new both showing just over 1v
I assume take the power source cable off as well right?
Might be my meter, but fro a brief moment it shows the same reading as for USB flow meter 1.6xx and goes back to 1v on both of the aquaeros
Update:
We getting somewhere, both of my USB flow meters are working and showing in aquasuite under aquabus, so that means my Aquaeros Aquabus is fine.
So now to the PA3 how do I darn make them work, none of them showing except the new one
The scary part is I have to move my whole system 250lbs to put everything back together and the water drainage .
so at least i feel little better that the worse scenario I will need to purchase 6x PA3
I don't mind Aquacomputer is my favorite, despite this, it was my fault and I just purchase new Aquasuite license to show my loyalty
I will definitely feel better if all of my PA3 were good
Lets work on the PA3 now