Sie sind nicht angemeldet.
Sonntag, 7. April 2019, 22:52
Sonntag, 7. April 2019, 23:12
There are now two dedicated flow sensors on the aquaero 6.One of the fan outputs will have to be used with one of the flow sensors as there is only one dedicated flow sensor on the Aquaero 6 PRO.
Sonntag, 7. April 2019, 23:16
That is very helpful indeed, I thank you for the info! It may be enough as I am willing to give up some granular control of the fans if it makes things easier and cheaper.There are now two dedicated flow sensors on the aquaero 6.One of the fan outputs will have to be used with one of the flow sensors as there is only one dedicated flow sensor on the Aquaero 6 PRO.
Both the Flow sensor port and the old aquabus Low port are dedicated as ports for the Flow sensor high flow.
May not be enough, but you should have four PWM fan ports available with two high flow sensors
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »InfoSeeker« (8. April 2019, 07:09)
Two additional thoughts:
1. The clock module is not needed unless you will NOT be keeping a USB connection between the aquaero & motherboard.
2. It is less costly to purchase a Quadro, or two, for additional PWM fan ports/control than to purchase an aquaero 6 lt for a slave.
EDIT: The Quadro would also allow you to drive both RGBpx LED rings for aqualis.
-