I'm setting up a dual loop system and have High Flow Sensors (non-USB 5306
for each loop (so 2 sensors total). I have a single
Aquaero 6 LT for fan/pump control. I want to read the flow for each sensor but there's only one flow sensor header on the Aquaero 6. I would think a Y-splitter off the single 3-pin flow header would not work. Is there a solution that would allow me to monitor the flow for each sensor?
I read another post on OCN that said that up to 4 flow sensors could be used with a splitter, but that was for the USB version, and Shoggy mentioned all 4-pins would need to be connected, and these are 3-pin sensors. So I wasn't sure if something similar would be possible with the non-USB flow sensor.