Hello, I purchased a aquaero 6 and mps200 recently have been getting them set up on the test bench. Everything looked good and I'm really impressed with the Aquasuite software.
I didn't realize the MPS200 wouldn't come with an aquabus cable, so I ordered one and that came in yesterday. Now i'm having an issue that I can't get an aquabus connection between the two:
The aquabus cable is connected from "Aquabus high" on the aquaero 6 to the aquabus connector on MPS200... Its a keyed cable, so probably correct.
I had updated the firmware on both devices previously.
I used a meter to verify the aquabus cable (no open or shorted pins).
I let the everything sit overnight with no power.
I tried the "reduce bus speed" option.
I tried a couple of different addresses for the MPS200 (even though its the only thing connected).
I disconnected everything else from the Aquaero 6 to ensure there wasn't some sort of interference.
I tried "reset device to factory defaults" on both devices.
Is there anything else am missing or could try?
I also have an octo on backorder. So eventually I'll be able to test that as a third device.
Thanks Mike