Sie sind nicht angemeldet.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Dundys« (1. Juli 2020, 21:44)
I don't run PA3 any longer so I'm not 100% sure if the steps are the same as the aquasute versions have change so is maybe that process as well. There was a time I had 7 Ultra connected to my aquaero and in aquabus, there is or I remember was drop down menu with devices and you choose and add # 50 as your PA3 reboot and it should show. I think you have to first connect PA3 directly to your Mobo with USB cable and once that is set you can run only aquabus cable. If this is not totally correct I apologize, Its been a while, I'm sure someone can confirm and correct my info.
It all should work for you, just a matter of taking your time and It will come together.
You are not a pain, you here to ask for help. Yes plug the USB cable between mobo and PA3 itself it should show in aquasute. Once you set the ID for PA3 you can disconnect from mobo and connect aquaero with USB to mobo and PA3 to aquaero via aquabus, It should show then
Dieser Beitrag wurde bereits 3 mal editiert, zuletzt von »Dundys« (1. Juli 2020, 22:16)
That I wouldn't know. Do you use splitter, that is something you might need, but tbh I never used strips so on this one someone else can chime here, be patient, this forum is not the most busy sometimes, but there are few long time member that will definitely give you the right direction
O I see, Yes, give a little time, someone with more knowledge will help you.No, it is three individual 3 Pin connectors.
Thats how I planned to fill up the three 3-Pin spots on the PA3.That I wouldn't know. Do you use splitter, that is something you might need, but tbh I never used strips so on this one someone else can chime here, be patient, this forum is not the most busy sometimes, but there are few long time member that will definitely give you the right direction
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Dundys« (1. Juli 2020, 22:19)
O I see, Yes, give a little time, someone with more knowledge will help you.No, it is three individual 3 Pin connectors.
Thats how I planned to fill up the three 3-Pin spots on the PA3.That I wouldn't know. Do you use splitter, that is something you might need, but tbh I never used strips so on this one someone else can chime here, be patient, this forum is not the most busy sometimes, but there are few long time member that will definitely give you the right direction
Good luck
-