• 19.04.2024, 19:11
  • Registrieren
  • Anmelden

  • Sie sind nicht angemeldet.

 

MPS 400 flow no reading ! WHY ?????

DirtyBear

Junior Member

Beiträge: 39

MPS 400 flow no reading ! WHY ?????

Dienstag, 28. Juli 2020, 11:17

Hi

Before the MPS 400 working great at my old setup

But after I switch to a new case the 6 LT did detect the MPS 400 but no reading

so please is there any way I could fix this ?? Please help
»DirtyBear« hat folgende Bilder angehängt:
  • Untitled.png
  • Untitled.png2.png

mditsch

Senior Member

Beiträge: 586

RE: MPS 400 flow no reading ! WHY ?????

Dienstag, 28. Juli 2020, 11:51

Zitat von »DirtyBear«

Hi

Before the MPS 400 working great at my old setup

But after I switch to a new case the 6 LT did detect the MPS 400 but no reading

so please is there any way I could fix this ?? Please help


maybe your flow is too low because of (for exmaple) air in the loop? Your MPS is specified from 80l/h to 400l/h. When your flow is too much below 80l/h it will be the case, that it is showing "nothing"

DirtyBear

Junior Member

Beiträge: 39

Dienstag, 28. Juli 2020, 19:03

If that simple I dont need to ask but thx

mditsch

Senior Member

Beiträge: 586

Mittwoch, 29. Juli 2020, 06:39

Zitat von »DirtyBear«

If that simple I dont need to ask but thx


then for helping, you should describe what you have made for to be sure, that you have enough flow in your build. What are with the temps of your componentes and water? Are they ok and on which level? If they are fine, then it could be, that your MPS is defect.

Bartdude

Full Member

Beiträge: 145

Freitag, 31. Juli 2020, 06:05

Another thing to check, when I installed my MPS400 I had a similar problem but mine was caused my a pressure build up within the loop. To fix it I installed THIS to the top of my reservoir.

Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Bartdude« (31. Juli 2020, 06:07)

"no shit lady, does it sound like i'm ordering pizza?"

Ähnliche Themen