Hello,
I am having problems with my Quadro device - wondering if anyone else has experienced this or has any suggestions. When making changes to fans on ANY of the 4 fan ports, often times the change does not stick. Example - fan at 50% - change to 60% - disk icon comes up, then goes away. Aquasuite shows set 60%, fan shows 50%. If I keep making changes and prompting the disk icon to come up, eventually the change will stick. It seems like the Quadro isn't accepting the data. I can even change settings on fan 1/2/3, settings do not seem to apply, then by the time I change settings on fan 4, ALL previous changes apply at the same time. I hope this make sense.
I recently bought a D5 Next pump in the system. This does NOT exhibit these problems and works perfectly fine. This "delay" also seems to cause issues with the "Curve Controller" on the fans being based on water temperature - like it's delaying the ramp up/down as it's not getting info.
I have tried different USB ports on the board (Asus Crosshair VII X470), as well as a complete format and reinstall of Windows, and a "factory reset" of the Quadro and nothing seems to help. When I first got my Quadro earlier this year it was on X.11 and it was always very responsive and worked well. Ever since X.12 firmware update, it's acted strange and I haven't been able to solve it but I figured either a firmware update or a windows reinstall would fix it. Unfortunately that's not the case - I've gone all the way to X.24 and still the issue persists.