Hi,
First off, I just want to say congrats to all aquacomputer staff. Impressive products and software.
I just finished my first watercooled build and I don't know if what is happening is normal or not.
Each time I start the aquasuite, the aquaero loses the connection with the MPS High Flow USB (53129).
no_flow.jpg
If I click on "Find aquabus devices", it is found again in no time.
flow_found.jpg
It is a fresh install, and all firmware components were updated. If it matters, connections are as follow:
As I read X470 Mobo USB drivers can give some kind of problems, I connected my Hubby7 to one of the internal ports of a PCI-e USB 3.0 Card, and the other one to the Aquaero. The Hubby7 is connected to a SATA plug and the jumper was changed.
Connected to this Hubby are an Aquastream XT, an MPS High Flow USB, and an MPS Pressure Delta 40 which I use as fill sensor.
The Aquastream XT and the MPS High Flow USB are connected through the Y-4 pin aquabus cable (53124) to the "High" aquabus on the Aquaero and the fill sensor is connected to the "Low".
Strangely, on the aquasuite tab of the High Flow all data seems correct. If I reduce pump speed the flow goes down accordingly, and the built-in temp sensor is accurate (got two inline more on the loop), so I am confused about why the aquaero cannot reach it.
Thanks for your time.