Perhaps I am the only one who has tried to do this, though that surprises me.
I want to set up aqua suite, configure all the RGBpx, build the curves and virtual sensors, and so on, with the devices simply powered and connected to a laptop, before completing the install into my PC.
To achieve this with the pumps, I would expect to be able to configure the pump controllers without the motors attached. Obviously this causes the NEXT to signal a critical alarm, with the incredibly loud and piercing buzzer going continuously, from in my case, two pumps.
I need to do firmware updates and all sorts of things before I am ready to test with water in a loop. Please could you consider some kind of “config” or “maintenance” mode that silences the alarms to allow this to be done?
Cheers.
Ben