System: Aquaero 6
I've recently installed a
53068 "High Flow" Sensor, it is landed on the port labeled Flow (left of the Aquabus Low port). I also have a
D5 PWM Pump (AQ-41105) landed in the Fan 1 port.
Two Issues:
1) In the Fans section of the Aquasuite
(Version X.29) software, I've set the pump to "PWM Controlled" under the Advanced settings tab. However, No matter what I do, it continues to run at max rpm even though 0.0V is listed. In the "Controllers" section, I created a "Preset value" rule for said pump and have tried adjusting the slider, but the RPM never budge from 4784rpm. What could be wrong?
2) Under the "Flow sensors" in the Sensors section of aquasuite, my flow sensor is listed, and correctly set to "Aqua Computer high flow ( 53068 )" for the Calibration value. I do show a reading of ~250 l/h. That being said, I would like to use this flow sensor to dictate the speed at which the PWM Pump operates. I cannot find a way to utilize the flow sensor as an input in the Controllers section.
FWIW, this is a dual pump system for redundancy, the other pump in the loop is a D5 Vario set to low RPM for a baseline flow rate. This D5 Vario is not connected to the Aquaero.
Any help will be greatly appreciated!