Sie sind nicht angemeldet.
Zitat
A minimum operation noise is achieved by an optimally calibrated bearing play at each sensor. In addition, the new sensors can be operated in any mounting position. Furthermore, the direction of flow is still not specified - this ensures an easy installation in any system. The measuring system has also been extended in its measurement range and can now measure flows of 35-1000 l/h!
Heh, I think JasonMorris was taking a poke at me for asking a question when I had replied to a similar question earlier.
My question was a bit rhetorical, the introductory post states the following:
Zitat
A minimum operation noise is achieved by an optimally calibrated bearing play at each sensor. In addition, the new sensors can be operated in any mounting position. Furthermore, the direction of flow is still not specified - this ensures an easy installation in any system. The measuring system has also been extended in its measurement range and can now measure flows of 35-1000 l/h!
But now we are advised not to exceed 300l/h or risk noise, and the manual advises to install the High Flow Next with the 'button' up for best result.
Luckily, I am able to install vertically, with >100mm straight in & out of the sensor.
And even if I am able to achieve very high flow, I will set the ceiling at mid 200l/h max... no reason for more.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »JustinThyme« (17. Januar 2021, 07:03)
-