Sie sind nicht angemeldet.
It may take two steps:
The specs look right.
EDIT: make sure you get an O-ring for the male M5 end.
I am not following you, can you provide links to what you have?I have bought the alternative ones, single one fits the sensor’s m5 and screws in perfectly but issue is you can’t but second one next to the other, there has to be another solution !?
I suspect most any 5mm ID O-ring would do... HERE are 4 posibilities from your vendor, 2 materials types and 2 thickness' (1.5mm & 2mm)Zitat
the one I bought did not come with an o-ring, is there a link to the o-ring that I should be using ?
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »InfoSeeker« (8. April 2021, 20:36)
I am not following you, can you provide links to what you have?I have bought the alternative ones, single one fits the sensor’s m5 and screws in perfectly but issue is you can’t but second one next to the other, there has to be another solution !?
I suspect most any 5mm ID O-ring would do... HERE are 4 posibilities from your vendor, 2 materials types and 2 thickness' (1.5mm & 2mm)Zitat
the one I bought did not come with an o-ring, is there a link to the o-ring that I should be using ?
Edit: Maybe you mean you cannot screw 2 of the adapters into the MPS unit because the ports are too close to each other? What are you doing with the MPS 40 Delta, pressure drop or res coolant height?
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »D11125225« (9. April 2021, 02:03)
If the M5 to G1/8 fittings are too large, you will have a bigger problem getting two G1/8 to G1/4 next to each other. This, and flow rate not being an issue, is probably why they went to the smaller fittings.to follow here is a photo I uploaded shows the issue:
https://imgur.com/gallery/C6XXCsX
Yes you got it right, I cannot screw 2 of the adapters into the MPS unit because the ports are too close to each other, im using it for pressure drop and im trying to link it directly to the hardline loop without the hose.
This is probably a moot point as you most likely will not be able to use this fitting, but the outer diameter depends on the thickness of the O-ring. With a 5mm ID, and 1.5mm thick O-ring, the OD will be 8mm. For a 5mm ID with a 2mm thick O-ring, the OD will be 9mm.Zitat
in terms of the o-ring there are different outer diameter sizes as well (8mm/9mm), any idea which is relevant ?
I presume FKM is better than nitrile rubber because it lasts longer
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »InfoSeeker« (9. April 2021, 04:43)
-