Sie sind nicht angemeldet.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Cobra26« (16. April 2021, 21:23)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Cobra26« (21. April 2021, 05:04)
Zitat
Too much head pressure can cause poorly connected fittings to leak when at a lower pressure they wouldn't normally leak.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »InfoSeeker« (21. April 2021, 05:17)
[snip]
Which reservoir well the fitting you showed me which i need to attach the res directly on to the INLET
of the dual D5 pump i was looking at EK-RES X3 250 Lite or i buy seperate tube with seperate upper and bottom top.
Here is my setup with picture on this link (still need to reply since i had personal issue i had to tend to)
https://www.overclock.net/threads/2-x-d5…/#post-28776208
[snip]
Which reservoir well the fitting you showed me which i need to attach the res directly on to the INLET
of the dual D5 pump i was looking at EK-RES X3 250 Lite or i buy seperate tube with seperate upper and bottom top.
Here is my setup with picture on this link (still need to reply since i had personal issue i had to tend to)
https://www.overclock.net/threads/2-x-d5…/#post-28776208
Depending if you're mounting the radiator vertically or horizontally, you will need to attach the ULTITOP DUAL D5 feet so the IN port is located to the top. ([attach]8372[/attach])
Then you screw the Rotary Connector into the Ultitop IN port. (the fitting is 13.8 mm tall)
Lastly, screw the bottom port of the EK-RES X3 250 Lite onto the Rotary Connector (assuming you are returning to the top).
The advantage of the Rotary male/male connector is that you can rotate the tube to align the return port at the top for best installation.
The only question I have is that the bottom port of the Res X3 is slightly recessed, but I believe the rotary fitting should fit. ([attach]8373[/attach])
Thanks for the reply,
Good catch on the recessed res from EKWB if the LITE might be an issue i can always go for a stand alone 200mm tube and 1 upper top and one base top this should hopefully be ok.
Yes a rotary fitting should make the direction more access-able since the top only has a inlet and outlet i am forced to use the res top as an inlet might as well use a 90 degree fitting (rotary).
-