Leakshield - configuration wizard doesn't seem to complete (overview page still says it needs to be configured) - English forum

Leakshield - configuration wizard doesn't seem to complete (overview page still says it needs to be configured)

Junior Member

Leakshield - configuration wizard doesn't seem to complete (overview page still says it needs to be configured)

Dienstag, 27. Juli 2021, 16:10

I ran the wizard, it found my pump and flowmeter automatically and I selected the correct res. Left the default setting be.

This is what the page looks like now - does it need some more time? I am not able to select SHIELD in the mode area.
It does indeed generate and holds a vacuum so I am doubting that release is in fact the active mode.

FW: 1006
Aquasuite X.41

»etoel« hat folgende Datei angehängt:

Leakshield status after wizard.jpg (428,18 kB - 60 mal heruntergeladen - zuletzt: 6. April 2024, 05:06)

etoel

Junior Member

Beiträge: 39

Dienstag, 27. Juli 2021, 17:53

A shutdown and switching off the PSU resulted in a Shield state, but still complaining about unfinished configuration

etoel

Junior Member

Beiträge: 39

Dienstag, 27. Juli 2021, 17:57

One more round of doing the wizard resolved the issue - did the exact same thing, but now the configuration stuck.
Not sure what happened, but all good now.

Leakshield - configuration wizard doesn't seem to complete (overview page still says it needs to be configured)

Leakshield - configuration wizard doesn't seem to complete (overview page still says it needs to be configured)

Ähnliche Themen