Sie sind nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Hufeisen« (1. Dezember 2021, 18:17)
The EK Vardar Fans dont work with the Splitty9. The problem is, that all Tach Cables are connected together in the Splitty9, and the Vardar Fans dont like that.
As a Workaround, you have to remove the Tach Cables from all Fan connectors (except for the Fan that is connected to the RPM port on the Splitty9)
You can try this. If EK fixed their Fans, it works, if not, you have to make modifications.I was anticipating to connect six fans to each splitty, each fan directly to the splitty,
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Hufeisen« (1. Dezember 2021, 23:16)
interesting.It's true cable splitters don't have the tach signals connected at all, only one fan has it; all the others are absent.
Nothing a flush cutter can't solve by snipping the useless pins on the splitty, or cutting the tracks. But that looks like an unusual oversight fron Aquacomputer too, even if the fans shouldn't behave like that either. There's no functional need to run a track to those 8 unused pins, or to ground them. They should have been left floating.
As for the speed control, the controller reads only one fan speed from the fan connected to the socket with "RPM" marked.
The PWM signal is the same for all the fans (that's why these are sometimes called PWM repeaters), so, if the fans are the same model, they will run at the same speed.
It’s a shame this is not mentioned in the Splitty9 product details or manual. But will try the clipped pin method if this becomes an issue for me.
Zitat
By setting the jumper to the “aquabus” position, all four
aquabus signal lines are forwarded to all black connectors.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »InfoSeeker« (2. Dezember 2021, 16:17)
-