Hi, hoping someone else has encountered this problem before.
I just upgraded from an old aquaero to 6 LT, I have also a aquastream XT. Both connected using USB and aquabus. Only other ting connected are 5 fans.
This is all connected to a Aorus Master (z390) board and using a Corsair HX850 PSU.
Now after the switch whenever I run shutdown from inside the OS, the computer will turn off. But the instant it is off it will start up again by itself.
I did all the normal troubleshooting, disabling all I could find in device manager from waking computer up. To resetting bios. Nothing helped.
As the only change is the new version of aquaero, I tried to remove the power to the board and booted up win again.
Now doing shutdown, it would stay off.
Plugging power back into the aquaero, the computer would start powering itself up again after shutdown.
Anybody seen something similar in their setup, I'm kinda at my wit's end here
Thanks
I am something similar but not exact:
Need help troubleshooting or determining if this is a known issue. In short, the x47 service hard crashes my PC by:
- Causing hard down "like a power supply cut off" OR
- A hang state that a "hold power button" force shutdown or even the clear CMOS button cannot trigger (only PSU switch)
My troubleshooting has included:
- Full install and uninstall of x47 (with reg clean etc).
- For both my Aquaero 6LT and D5 Next - updated firmware (to reflash) and reset to factory defaults
- Trying to run with and without any settings
The software can stay open but only with service disabled... once enabled the symptoms appear within minutes usually.
Anyone seeing that... and work around... or at least where to I DL the old software... right now system is unmanaged.
Thanks