Hello all,

Just installed my new quadro and getting to grips with it.

In one of the 4-pin headers on the quadro i have connected a 3-pin connector from an alphacool flow sensor (tried to get the NEXT but out of stock and i just thought I would put it in and see what happens).

Basically what I am trying to do within aquasuite is take the rpm from the flow sensor, convert that into a L/h reading (using alphacool provided table) and then use that L/h "value" as an output to control the pump speed, which is also connected to the quadro.

Is this possible? I know it sounds like a very roundabout way of doing things but I figured I would give it a go.

Thanks for your time.