16.04.2024, 12:43
Sprache ändern
Registrieren
Anmelden
Sie sind nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
Donnerstag, 27. Januar 2022, 02:25
My vision keeps losing the sensors? the only display on it that works is the H2o temp which is via the connected aquacomputer sensor via the visions onboard connector. The only way to get the other settings to show again is to restart the aquacomputer service or restart my PC. any reason for this? is it a software error?
Here are some pics of my vision sensor and display setup.
Also if i get an aquero 6, will my EK PWM D5 work ok with it, i heard there are problems with the PWM version.
Here are some pics of my vision sensor and display setup.
Also if i get an aquero 6, will my EK PWM D5 work ok with it, i heard there are problems with the PWM version.
Donnerstag, 27. Januar 2022, 05:29
You can connect them with that cable, but the OCTO will not give a correct flow rate. It's about 3 times higher than actual. I have mine connected that way right now. Look at the options under the flow sensor on the OCTO. It does not have a drop down option for the high flow NEXT.The Aquabus can only be used to connect devices to an Aquaero.
Directly you can connect the high flow 2 and LT to the OCTO, the high flow NEXT is connected via USB to the motherboard and is then visible in the Aquasuite.Oh wait, with this cable you can also connect the high flow NEXT directly to the OCTO.
Donnerstag, 27. Januar 2022, 14:07
When I try and select "Aqua Computer high flow (53068 )" as the "Sensor Type" I get a value of 29.89 l/m on the OCTO. The high flow NEXT says the flow is 2.57 l/m. Using another standalone flow meter I get a 2.6 l/m value so the high flow NEXT appears to be correct and accurate.you have to use the high flow in the drop down list
Feature Request: Select high flow NEXT under flow sensor in OCTO
Donnerstag, 27. Januar 2022, 16:45
Thanks! Found the option under "Alarms" "Signal out out" never thought to look under there.You have to configure the output signal in the High Flow NEXT!When I try and select "Aqua Computer high flow (53068 )" as the "Sensor Type" I get a value of 29.89 l/m on the OCTO.
Ähnliche Themen
-
English forum »-
aquaero 6 + RGBpx LED ring
(19. August 2020, 11:51)
-
- English forum »
-
octo aquabus cable
(20. Juni 2020, 20:24)
-
- English forum »
-
octo/quadro controllers (question/suggestion)
(1. Juni 2020, 06:25)
-
- English forum »
-
Questions on adding Octo to Aquaero
(14. Mai 2020, 23:04)
-
- English forum »
-
Quadro, octo, and aquaero connection
(23. April 2020, 04:01)