Hello there, everyone. I have the
PCIe slot bracket with fill port for LEAKSHIELD, and can't quite figure out how to integrate the slot bracket to my hardline loop properly.
I tried the naive approach of a horizontal tubing run to a T-block, merging with the GPU block outlet. This led to air getting trapped in the run to the slot bracket after filling the loop--which is rather unsightly, and causes bubbles to occasionally get sucked into the loop. Since there isn't any flow there, no amount of case tilting or LEAKSHIELD deaeration cycles can get it out.
I'm used to the idea of a fill port at the top where air can escape, so I'm not sure if I'm missing something obvious here. Is there a right way to install the bracket that avoids the trapped air issue?