Hello,
I have a D5 Next, Leakshield, High Flow Next and Octa RGB. The Octa controls the fans, and much of the RGB.
I have 2 windows installs on the same machine. My primary, and my secondary.
I do not have a signal wire connecting anything to the octa, so I have to use, I guess they are "soft" sensors, utilising the water temperature from pump or flow meter to give me water temperature.
So have to manually assign water temperature soft sensors to the Octa sensor suite, within the AquaSuite. I have to do this on both the Primary and Secondary windows installs.
The problem is that they are not the same sensor.. so when the water temp is correctly set in my Primary install, it does not work when I boot into my Secondary install. Each time I change the windows boot, I have to manually go into the Octa --> Fan --> and reassign it to the soft sensor.
Is there a way to share the program/sensor data between my installs, such that I have the correct fan settings regardless of which Windows Machine I boot from?
If not, can I get around this somehow? I am in Australia and can't afford the 60euro or so to get a single signal wire sent over, and I am not even sure if this would do the trick).
Thanks!
Take a look at
Aquasuite in a Dual Boot Environment: Shared Config?