Mine has never done this and from just the graph I can't even guess what may be causing this. Post a screen shot of the whole X.59 Status screen and also export the event log and attach it

I am surprised there are no P1 + P2 + Q + D Waterproof Membrane values, but as you failed to post the event log I asked for I can't see what happened before the cycling.

Currently my best guess is that either that the Level Measurement failed or never happened and there is now a lot less than 107ml of air in the reservoir

Were it my system I would do as follows:

1) Save the current event log and then clear it.
2) Set the mode to Release
4) Wait 15 seconds
5) Set the mode to Monitor and see what happens, it should so a Measure Level and then the P1 + P2 + Q + D Waterproof Membrane values should be reported.
6) As to what I would do next would depend on what happened

Zitat von »Ytterbium«

there was a warning that the membrane was not function to expectations.

Ah, I suspect this is the root cause of the overshoots, but I have no idea what caused this to how to fix it.

It would be sensible to post a screen shot of exactly what was reported, were there any error codes?

I suspect you should email support@aqua-computer.de, include as much detail as possible

Probleme mit Leakshield und Fillport


Translation from the above post:

Zitat

Your membrane is clogged. You can see this from the spikes in the pressure curve. Change your coolant and drip a few drops of isopropnaol onto the membrane. Wait 5 minutes, vacuum with kitchen roll without touching and repeat this 5 times. If the peaks remain, then the membrane must be replaced.