I also have a High Flow Next connected. Do I need an Aquabus splitter cable to connect both devices to the Aquaero, or can I just use the other Aquabus low port?
Please read the manuel:
Connectors “Flow 1” and “Flow 2”
Connectors for flow sensors. Use sensors and cables specified by Aqua Computer only!
Please note: The “Flow 2” connector may also be labeled as “aquabus low” on the device. The function of this header is determined solely by the current firmware version of the aquaero. Starting with firmware version “2010”, this header can be connected to a flow sensor irrespective of connector labeling.
Pin assignment: Pin 1: GND
Pin 2: 5 V
Pin 3: Speed signal
Compatible flow sensors:
- Flow sensor with 5.6 mm nozzle (53061, requires cable 53027)
- Flow sensor “high flow” (53068, requires cable 53027)
- Flow sensor high flow LT (53291)
- Flow sensor high flow 2 (53292)