Sie sind nicht angemeldet.
Dieser Beitrag wurde bereits 11 mal editiert, zuletzt von »Mike817« (16. Februar 2024, 15:26)
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von »PvF« (16. Februar 2024, 06:30)
Thanks, I'm glad you pointed this out. I should have said 16 AC USB devices, not sensors -- unless it's been updated since v7.47 (it's only mentioned in the hwinfo forums , not the release notes). I edited my post to mention USB devices instead of sensors.# 2
Yes, HWInfo64 can read the Sensors from the AC devices and the imported soft. Sensors of the device.
The virtual Sensors from "Playground" are not readable. There is no limit of 16 sensors
Here are the Sensors in HWInfo from my devices: [attach]10739[/attach]
Hi Mike817 and welcome to the forum. I am the OP of that thread on the HWINFO forum and can confirm that Martin increased the limit for Aquacomputer devices from 8 to 16 in v7.47-5120 beta.I should have said 16 AC USB devices, not sensors - unless it's been updated since v7.47 (it's only mentioned in the hwinfo forums , not the release notes). I edited my post to mention USB devices instead of sensors.
The Aquabus x4 module is only required if you use 2 or more Calitemp sensors.I believe that if I do end up using a Calitemp sensor, I'll also need an Aquaero module (I assume it would be v6) to connect it to. If that's true, I think I also need a Aquabus x4 so I have 1 connection for the Calitemp and other(s) for the other devices. Is that correct?
It depends on how many fans you connect to the Aquaero. A Heat Sink is only required if you use a lot of voltage regulated fans. If you connect PWM Fans only, you dont need a Heat Sink.I've read a number of articles about Aquaero modules getting very hot. If I use an aquaero, how would I know whether I need additional heat dissipation, like the Passive Heat Sink ? That product page also shows an image of a water block attached to the heat sink for an aquaero v6, but I couldn't find a product page for it. Is that even something to consider (assuming it's available)?
The Signal to the Display is very sensitive. A short extension cable of about 5cm should work, but it is not recommended to do this. Anyhing longer than 10cm has a very high chance that it will not work.If I went with an Aquaero XT or Pro, can I use an extension cable between the core module and the display?
Yes, the configuration information is saved in the device, the Aquasuite is not required to run.Is it correct that I can configure everything with Aquasuite and then once I'm done, I'd never need to run Aquasuite again unless I needed to change the configuration - in other words, all my configuration information would reside on the various AC modules and they would work together as configured, even if Windows isn't running
-