Good Afternoon Everyone, I have an Aquaero 6LT and need some guidance on how to connect the following.
I am building a dual loop system, However one loop will have 2 480's in series (One Push Pull, The other Push) 11 fans total. What do I need, Or how do I wire up 12 fans to only utilize one of the FAN channel connections on the Aqauero? The other loop will utilize FAN channel 2, And finally Channels 3 and 4 will be Pump 1 and Pump 2.
For parts, I currently have two Splitty9 fan splitters (Not Powered). The fans are Noctua NF-A12x25 PWM. Can I daisy chain these two splitters in some way? Or should I be using two Splitty9 Actives?
Or would it be ok to get two Y 4 pin fan splitters and reduce 4 fans into two connections and then just utilizing one Splitty 9 for all 11 fans?
Thank You.