Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum.
Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert.
Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können.
Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang.
Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
I have the AC Flow Meter and I will be using 1/2" barbs with G1/4 BSPP threading. I just took a look inside the opening of the flow meter to see that it narrows DRASTICALLY.
Wouldn't this have a terrible impact on my flow rate when included in my loop?
-d3d
Probably if you are using a high flow 1/2" system as the flowmeter was designed to be used on a system that does not need "high flow" in order to work.
well not necessarily... if you have the time.. i would check the temps of when you have the sensor.. and when you don't have the sensor... if they are a big difference then scrap the sensor.. but in my honest opinion.. I don't think the flow makes that much of a difference (especially if you have aqua computer blocks).
Ed
Alright, I'll keep that in mind. Thanks.
What blocks are you planning to use?
I'm using a DangerDen Maze4 gpu block and a Swiftech Apogee cpu block.
I'd look for another flowmeter then - the AC one isn't suited to your loop.
Great, I appreciate it.
I just figured the AC flowmeter would be my only choice because I need the specialized output designed for an Aquaero.
You find any alternatives? Should I try to enlarge the flow meter hole?
I'm familiar with drill/tapping, I did it for the aquatube for 1/2" fittings..
23.04.2024, 17:18
Sprache ändern
Registrieren
Anmelden
