Sie sind nicht angemeldet.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »WebMaximus« (15. Februar 2009, 01:50)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »WebMaximus« (15. Februar 2009, 14:18)
2% is the required and maximum amount that should be used. Overdoing it creates all kinds of problems. To get rid of the air turn on the deaeration mode. You will find this in the pump section of the software.Managed to set the system up yesterday by guessing and with some help from Google Translate...however I have one question. I used distilled water and then added some of the ACfluid that came with the product but I might have added too much because now after running the system for about one day the water is almost white like milk and I also seem to have lots of air in the loop and not sure how to avoid that or how to get rid of it when it's already in there...?
Thanks in advance for any advice!
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von »WebMaximus« (17. Februar 2009, 00:31)
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von »Top_Nurse« (17. Februar 2009, 06:18)
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von »WebMaximus« (17. Februar 2009, 12:49)
-