System start today had PWM port 3 (pump 1) at Power preset, and PWM port 7 (fans) low temp at 1°.
But I may have still erred, and I reset all 3 profiles again.
It would be very useful if there were a template available that listed all the settings a profile is set to.
I assume the profile settings are stored in the device's saved profile, but it is a long string sans labeling. {
octo_profile_2021-11-13_06-50-35.rar}
Is there a profile save for the Playground?
There are a lot of settings there.
Why not swap the Pump headers 2,3 & 7 to say 4,5 & 6 , configure them as you have done now on 2.3 & 7 and see if the problem persists
FYI the max total load is 100W with each individual header being up to a max of 2o(or is it 25?) W
Pump 1 was originally on PWM port 1, and I moved it to port 3 to check port failure.
The problem appears to be with the pump, it looks like it is drawing too much current.
PWM port 7 has a splitty 9 on it with 9 Noctua 'NF-A14 industrialPPC PPC-2000 IP67' fans on it. Max power draw/fan = 2.16w * 9 = 19.44W total
The pumps draw power from a separate source, not from the OCTO, so power should not be an issue here.