I saw that the PRO 6 can support up to two Quadros, but I can't figure out where to plug them into the PRO.
Buy a
Aquabus Y-Cable to connect both Quadros to the Aquaero 6, and put the Y-Cable on the Aquabus connector on the Aquaero.
Then buy two regular
Aquabus Cables to connect the Quadros to the Y-Cable on the Aquaero.
If I hooked one up to a USB on the Motherboard and the other on the PRO, will the software pick up the one from the MB?
Yes.
My recommendation for the first setup:
Connect both Quadros with USB to the motherboard. Start the PC and open the Aquasuite software. Do the firmware updates (if necessary). Then change the Aquabus Adress on one of the Quadros. The Aquabus Adress needs to be different on both Quadros for the Aquabus to work.
Then shutdown the computer, disconnect the Quadros from the USB, and plug them into the Aquaero with Aquabus cable. Connect the Aquaero to the motherboard with USB. Start your PC, open the Aquasuite Software again and everything should work.
I am pretty sure I finally figured out how to attach the flow sensor to the quadro, no directions yet again.. but pretty sure it just goes into the flow sensor port on the Quadro, and all the other wires are not needed for my setup.
Correct. Choose the wire that fits into the flow sensor port on the Quadro. The other wires are not needed for the High Flow LT.