No Fan Power on Headers 1 and 3

SNTmods

Junior Member

Donnerstag, 4. November 2004, 08:23

1

There seems to be no available power to fan headers 1 and 3 on the Aquaero, 2 and 4 work fine. I am currently operating under the 3.22D firmware too, any help would be appreciated since Im doing this for a customer of mine.

-Dan

Was an early adopter of Aqua-Computer watercooling in the U.S.

Stephan

Administrator

Re: No Fan Power on Headers 1 and 3

Donnerstag, 4. November 2004, 11:40

2

If there is no power on two channels, please reset the EPROM of the aquaero by pressing the set-key for 3 seconds on power on.
After that all outputs should have maximum power. If not there is a hardware problem on the aquaero board.

Chewy

Moderator

Re: No Fan Power on Headers 1 and 3

Donnerstag, 4. November 2004, 11:49

3

but be patient... NOT longer than 3 seconds... (!!!) the second part of the erasing function is to kill the firmware from the aquaero and this would be the last "beep" from your ae....

you should see a message "erasing eeprom...." and nothing further.

freezefreaks.de - design and silence

SNTmods

Junior Member

Re: No Fan Power on Headers 1 and 3

Donnerstag, 4. November 2004, 12:06

4

Zitat von »Stephan«

If there is no power on two channels, please reset the EPROM of the aquaero by pressing the set-key for 3 seconds on power on.
After that all outputs should have maximum power. If not there is a hardware problem on the aquaero board.

The EPROM reset doesnt even seem to work. I never get the "warning" statement.

And now the Aquaero turns off completely after 15 seconds or so after displaying the first title screen.

-Dan

Was an early adopter of Aqua-Computer watercooling in the U.S.

Chewy

Moderator

Re: No Fan Power on Headers 1 and 3

Donnerstag, 4. November 2004, 14:27

5

turn off the power. disable the ae from its power source for at least a few minutes. restart.

does this works or did you even try in this way ?

freezefreaks.de - design and silence

SNTmods

Junior Member

Re: No Fan Power on Headers 1 and 3

Freitag, 5. November 2004, 00:47

6

Zitat von »Chewy«

turn off the power. disable the ae from its power source for at least a few minutes. restart.

does this works or did you even try in this way ?

This doesnt work for me at all, I still cant reset the EEPROM.

-Dan

Was an early adopter of Aqua-Computer watercooling in the U.S.

x-stars

God

Re: No Fan Power on Headers 1 and 3

Freitag, 5. November 2004, 16:28

7

The only opportunity will be in sendig the Ae to the support for RMAing :-/.

cya
x-stars

"Live free or die: Death is not the worst of evils."